Hi all,
This profile is based on DCS-BIOS Plugin

To use this profile you need to:
- Install & setup DCS BIOS (https://dcs-bios.readthedocs.io/en/latest/installation.html)
- Install DCS-BIOS plugin for StreamDeck (https://github.com/toureiffel/streamdeck-dcs)

Automatic startup How-To-Use instrucions

set "INS default Alignment" to "PRE-ALIGNED" in DCS OPTIONS / SPECIAL / AV-8B N/A 

- open a HARRIER COLD&DARK situation
- press START 1 (it performs normal startup procedure including ENG start switch set to 'ON'
- When ENG RPM STARTS RISING, move throttle lever forward to 'Ground Idle' an then to raise RPM until complete start and stabilize (RPM should reac round about 285) 
- press START 2 (it performs other actions, that I normlly like to have done) 

That is done! 
after START 2 actions completed, you will also have INS Switch already set to NAV (and inertial alligment correctly completed)

Of course you can customize START-1 and START-2 actions: if you like you can remove/add actions, change order, just do it using streamdeck software 


Now you can go through and..
- Switch int/ext lights as desired
- EHSD
- Rearm & Refuel
etc..

----

GENERAL NOTES:

button state on streamdeck are not bi-diretional synchronized with relative state in DCS (due to DCS-BIOS that does not read DCS buttons status; it only send actions)
So you will need to sync/allign manually once you start your mission (example: if in DCS the 'landing/taxi lights' are 'off' and in your streamdeck the button is 'on', you have to witch it off in your streamdeck to sync to DCS state)

some commands are based on Keyboard shortcut:
- open/close canopy
- Flash light
- NVG
- other functions not related to aircraft such as : briefing, menu radio, Track-ir, kneeboard etc..

Remember to run StreamDeck Software with 'Administration rights' in order to let it work properly

THAT IS ALL FOLKS!
Hope you enjoy my profiles!

PVI Maverick
www.pvi.it

